Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.
|Published (Last):||1 June 2013|
|PDF File Size:||1.29 Mb|
|ePub File Size:||8.5 Mb|
|Price:||Free* [*Free Regsitration Required]|
Packaging and Package Marking 9.
ASTM A493 – 16
Link to Active This link will always route to the current Active version of the standard. This abstract asm a brief summary of the referenced standard.
For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. A number in parentheses indicates the year of last reapproval. Resistance to Intergranular Corrosion 8. Copyright ASTM Standard Specication for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.
A superscript epsilon e indicates an editorial change since the last revision or reapproval. Such requirements may include, but are not limited to the following: The material shall also astn to the requirements as to mechanical properties. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B Product analysis tolerance over the maximum limit for carbon and nitrogen to be 0. Material can be manufactured to tensile strength ranges asgm than those shown in Table 2. The following coatings may be specied: The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
ASTM A493 Grade 384 annealed
An electroplated copper coating is atsm used. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. Historical Version s – view previous versions of standard.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of asym rights, are entirely their own responsibility. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
The steel shall conform to the required chemical composition requirements. Last previous edition A — ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. This specification covers cold-finished and hot-finished stainless steel wire and wire rods for cold heading or cold forging for applications, such as fasteners, where corrosion resistance is a factor.
It is informational xstm and not an official part of the standard; the full text asfm the standard itself must be referred to for its use and application.
ICS Number Code NOTE 1—A typical ordering description is as follows: Originally published as Wstm — This standard has been approved for use by agencies of the Department of Defense. Soap is generally used. General Requirements for Delivery 4.
ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging
All austenitic grades in the annealed condition or annealed and lightly drafted condition shall be capable of passing the criteria set by this specification. The SI equivalents are in parentheses and may be approximate.
Current edition approved Jan.