ASTM A – Designation: A /A M – 01 An American National Standard Standard Practice f. This standard is issued under the constant designation a /a m; the number right away following the designation suggests the yr. according to the guidelines of ASTM E, “Standard Guide for ASTM A, “Standard Practice for Steel Casting, Austenitic Alloy.

Author: Daishura Grogami
Country: Montenegro
Language: English (Spanish)
Genre: Art
Published (Last): 10 December 2014
Pages: 265
PDF File Size: 19.43 Mb
ePub File Size: 13.3 Mb
ISBN: 688-3-13270-979-6
Downloads: 80556
Price: Free* [*Free Regsitration Required]
Uploader: Mugar

The possible extent of this difference is shown by the broken lines. If a tension test is not required by the applicable product specication, measurements may be made on a specimen cut from a keel block of a design in Fig. Asrm comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. Sources of error include the following:.

ASTM , Ferrite content (CF8M) – Metal and Metallurgy engineering – Eng-Tips

The quantity of ferrite in the structure is fundamentally a function of the chemical composition of the alloy and its thermal history. Download Now Defense manufacturing is all about project manufacturing and project accounting. Because of asym in chemical analyses, the calculated ratio may differ from the actual composition ratio and, as a result, the ferrite content may be higher or lower than indicated by the central X1.

These may so alter the magnetic response of the alloy that the indicated ferrite content is quite different from that of the same chemical composition that has undergone atm thermal treatment. All measurements shall be made on weld deposits as deposited. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.


Thanks for any help. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

It’s easy to join and it’s free. Download Now White Paper: This may be formed upon solidication from the molten metal delta ferrite or by transformation from austenite or sigma phase on cooling in the solid state alpha ferrite.

Standard Practice for Steel Casting, Austenitic Alloy, Estimating Ferrite Content Thereof

Join your peers on the Internet’s largest technical engineering professional community. Because of segregation, the chemical composition, and, therefore, the ferrite content, may differ from point to point on a casting.

Link to Active This link will always route to the current Active version of the standard. Sources of error include the following: Promoting, selling, recruiting, coursework and thesis posting is forbidden. Combining values from the two systems may result in nonconformance with the practice.

Individual reprints single or multiple copies of this standard may be asfm by contacting ASTM at the above address or at phonefaxor service astm. Sources of error include the following: NOTE 1—There may be a substantial decrease in the ferrite content of weld deposits after solution heat treatment in comparison with the as-deposited value.


Close this window and log in.

ASTM International – Standard References for ASTM A / AM – 14

If the composition ratio is 1. Originally published as A a080 Historical Version s – view previous versions of standard. Also, because the magnets or probes of the various measuring instruments are small, different degrees of surface roughness or surface curvature will vary the magnetic linkage with the material being measured.

Methods are described for estimating ferrite content by chemical, magnetic, and metallographic means. ASTM D e1.

BoxN. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Therefore, the precision of the ferrite content estimated from chemical composition depends on the accuracy of the chemical analysis procedure. Resources Digital Transformation may be defined in a number of different ways by analysts or enterprise software vendors.

Accordingly, if additional estimates of ferrite content are made by magnetic or metallographic methods, they can be expected to differ from the diagram value.

Regarding 2 and 3you need to know the niobium and nitrogen content of your steel before you carry out the calculation.