Vinyl Cutter Download Graphtec FC, Vinyl Cutter Machine Download Software Installation & Operation Manual in pdf ( MB) > Download Now. Manually Adjusting the FC ARMS Sensor Level for Glossy Media and Glossy Laminated Prints. When using some glossy media or when using glossy. View and Download GRAPHTEC FC Series user manual online. Cutting Pro . FC Series Plotter pdf manual download.
|Published (Last):||9 March 2016|
|PDF File Size:||2.58 Mb|
|ePub File Size:||7.34 Mb|
|Price:||Free* [*Free Regsitration Required]|
Manual Position Adjust Chapter 6: Mounting the stock rollers Insert the stock rollers into the slots on the rgaphtec stocker. The mark can be detected when the color of mark has a reasonable contrast against the background. Convenient Functions Chapter 4: Checking The Contents Checking the Contents Check that all of the standard accessories shown below are present.
Manua, further adjustment by performing cutting test after adjusting the blade length manually. The tool carriage will start moving, so there is a chance of injury. Supplement See “Attaching a Tool” P.
With thick film, additional time is required for the cutter blade to penetrate the media fully, even when the necessary cutting force is applied.
Setting range is from Make sure to set the plotting pen to the pen station at the turned off. It can read the mark in stable. Grzphtec blade mounted in the Remove any foreign matter inside the tool holder does not rotate Alignment registration mark cannot be used.
ARMS (Advanced Registration Mark Sensing system)
See “Setting Mark Distance” P. Confirm the Results of the Cutting Test the cutting test results, and adjust to optimal setting.
It will return to TEST menu screen once all the test items are completed. Adjusting for the Registration Mark Scan Position to scan the registration mark is positioned away from the tip of the tool pen tip.
Setting Regarding Interface Chapter 9: Setting Regarding Cutting Quality Chapter 7: Never use thinner, benzene, alcohol, or similar solvents to clean the casings; they will damage the casing’s finish.
Maanual pushing the tool holder in the upward direction, push the Supplement loupe all the way into the holder until its flange contacts the Use the same procedure to attach the pouncing Supplement TOOL setting screen is displayed. It will perform 2 axes warp adjustment in addition to the 2 fv8000 tilt adjustment and distance adjustment, so it can adjust more precisely than other methods. The tip of the blade is shaped as shown so the blade is facing the cutting direction even when it is cutting curved lines or corners.
But the cutting area becomes smaller with the bigger registration mark. Supplement Plot the registration mark before going to following steps if there is no registration mark written on the media. Enter text from picture: This function can also be used to acclimate long media lengths to the operating environment in order to minimize media expansion and contraction, and to ensure stable media feed operations.
Graphtec Manuals and Drivers
I nlet where the power cord graphhec connected. Cross Cut Manually Cross Cut Manually is cross cut at the position 15 mm behind the last cut position. Page Push roller The following describes important points for safe operation. Page 37 Press the media lock to engage it, and then pull the leading edge out of the front of the plotter so that it completely covers the media sensor.
But if there are many registration marks, it will take longer to detect, and the area that can be cut becomes smaller.
Page 20 Assembl y Assemble the left and right stand sides. Following items are displayed in the default screen. The symbol indicates an action that is prohibited. Unplug the power cord from the socket Prohibited See “Automatically Adjust” P.
Setting Regarding Cutting Qua For example, a white mark can be detected graphtdc a colored background. Settings Regarding Cutting Ti Replacing Cutter Blade 12 – Replacing Cutter Blade Replace the cutter blade by referring to the structure diagram of Supplement the cutter pen.
Unplug the power cord from the socket Contact your Graphtec call center if the problem still exists. The stand is made up of the following parts. Display when sort is on Manua,